Problem Solved
We have all seen this on site
The electrician has done the first fix and the plasterer has pushed the wires in and plastered over the lot.
To “get a good finish on the wall”
This can be prevented
We can all save time and money and get a better job done at the same time.
The is the typical starting point. The sparky leaves spare wire to allow for any problems at the second fix stage.
But if they were to use the ElecProTect™ system and fit a KUVA™ as shown here, the wires are protected.
The back boxes are fully protected from dust and plaster. Knowing this the electrician can prep the wires for the second fix now and save time later.
With the back boxes protected the plasterer's job is so much easier and they can get a great finish.
The plaster is easily removed when the electrician is ready for the second fix.
The KUVA™ is taken off and with a quick wipe is ready for use again these are reusable.
You have a perfect platering job and the back boxes so clean, the second fix can be done in your best suit.
We all save time and money.